Forum Replies Created
-
Posts
-
Re: Hotpoint 8932 F/C Compressor not starting
hi, to check if you have a duff compressor, and rule out that part, is to take an ohms reading across the three pins on the comp. the comp consists of a Run winding, and a Start winding. the third pin is Common. take a reading on all pins in turn. ie between S, C, say 25ohms.
then between C, R, with reading of 50 ohms. then through the last two pins R,S, this usually adds up to your both totals, and gives a reading of 75ohms, this then identifies which windings you have tested inside the compressor, and also tells you if the combined totals dont add up, which winding is duff.
TELL
p.s. hope this can helpRe: help.. e31 fualt code hotpoint ??
SORRY!! about that lads just seen top of page on forum..Fault Codes
TELL.Re: whirlpool washer/drier.fast advancing prog-end, info req
chris
have been told by customer it goes to the end.
TELLRe: whirlpool washer/drier.fast advancing prog-end, info req
cheers dave, left a little note for chris aswell
TELL.Re: whirlpool washer/drier.fast advancing prog-end, info req
chris
thanks for your reply, but, come to think of it, i’m sure it’s to the end.
will check??,
whats the prob’s if it’s on the spanner,
Ta TELL.Re: diplomat ADP8132 B/ In D/WASHER, PART No?, AND PRICE??
cheers craig, lights just come up on prog setting.nowt else. checked board though, 2 resistors goosed.
thanks will follow that up.
TELLRe: NEW SITE I FOUND??. ZANUSSI, CAN IT HELP.
cheers dave, i have connect-dist.and have visited the bosch site. just thought there might be something else out there.
TELL.Re: NEW SITE I FOUND??. ZANUSSI, CAN IT HELP.
SORRY MATE.
new at this game, old hand on the white goods and gas
tell.Re: NEW SITE I FOUND??. ZANUSSI, CAN IT HELP.
QUITE AGREE WITH YOU DAVE, BUT WHEN I WAS IN THE TRADE/COMPANY, IT WAS ALWAYS REFUSED FOR PARTS/SALES OVER THE COUNTER TO JOE PUBLIC, UNLESS THERE REPUTIBLE PROOF YOU COULD WORK WITH THESE. AS IN THE GAS SPARES/SALES.
PROOF REQUIRED. ie CORGI REG CARD.P.S. IS THEIR ANY DECENT UP TO DATE SITES THAT GIVE A GOOD PICTORIAL, AND MODEL INFO, TO GET PART No’S OFF ETC. COVERING A WIDE RANGE OF BRANDS. ALSO ON GAS APP’S. AT THE MOMENT I USE KITCHEN ECON, GAS APPS AT PRESTON. AND IF YOU CAN GET YOUR HEAD AROUND THERE SYSTEM HRPC.??
TELL.Thanks alot.. for info greatfully recieved, 1st two green neons on panel flashing.
traced fault to flood switch activated when i got there.
hose clips coming loose on these m/c’s from pump to sump. having to use old faithfull jubilee clips. nowt like the old stuff.TELL
