[toby1664]

Re: Zanussi ZSF6150 Dishwasher not heating

Thanks again, i think i’ll cut my losses and try a new PCB don’t fancy trying to get the temp snsor to seal again it may have to wait till pay day though lol willl let you know how i get on

cheers

Toby

[toby1664]

Re: Zanussi ZSF6150 Dishwasher not heating

forgot to mention the flashes are very fast its tricky to count does this mesn anythig else??

Toby

[toby1664]

Re: Zanussi ZSF6150 Dishwasher not heating

The turbidity sensor, it may have one as it has an auto wash function which i assume looks at the solids (TDS) or opacity of the water so if the dishes are clean low TDS, if they are dirty high TDS keep going?? where would the sensor be ?? or do you think i should cut my losses and just get a new PCB??

Thanks for your quick reply !

Toby

[toby1664]

Re: Zanussi ZSF6150 Dishwasher not heating

Thanks Penguin 45, you were right just as the others had found the pcb had a dry joint on the relay pin would never if thought it from looking at the top though no burning or any sign!! re soldered put it back now i have another fault, turn the power on select a temperature say 60 deg the machine seems to fill for a bit the little scrubbing brush LED goes out then aprox 30 seconds later the green temperature LED flashes aprox 11 times then the end of cycle (red)LED flashes once then the temp LED 11 times and so on,

The same repeats for any temprature, i have tried puting some water in the machine and it seems to pump out ok so i guess it is something to do with the heating circuit still any ideas????

Thanks Toby

[Author]

Posts