[tona955]

Re: Holes in clothes

Hi Greg,

Many thanks for your response, The machine is a Candy Sprint 1200 and we use Bold 2-1 powder.

How can I avoid thsi happening?

Cheers

[tona955]

Re: Candy 1200 Sprint

Hi,

Well you coudl be rite in saying that as it seesm to be OK now and is washing a full cylce, but the clothes still feel soaken wet…

I just spin them again and that sorts it out.better than what it was.

not sure what else i can check..

cheers

[tona955]

Re: Candy 1200 Sprint

Thanks for gettin back to me ..I have checked all switches and they are OK, it seems to stick after almost completing a cycle, stops just before it has to pour more water and then a final spin at this point i have to manually move the dial forward a notch.

just before it sprays the load and then spin it, thats where it hangs.

Woudl really appreciate a response on this guys.
thanks again#

[tona955]

Re: Candy Sprint 1200 Please help

Hi,

I have now resoldered all joints AND removed some coins from the drain pipe but it still will not work properly.

if i stick it on spin, it drains ok then does 2 short drum cycles and then stops and does no more.

Please help !!!

[tona955]

Re: Candy Sprint 1200

Hi,
I have replaced the bushes (£25) and it spins now but is still not rite, it now spins couple of turns one way then a couple turns the other way and thats it…plays no more..
I am going to take out the board tonight and check for dry soldering joints, can anyone suggest any further diagnostics?

Cheers

[tona955]

Re: Candy Sprint 1200

hi
Many thanks for your response.
regarding the water level it only does that sometimes, very rear. What it is doing now seems normal operation but the drum will not turn or spin, as mentioned earlier the water comes up to normal level but will not spin drum however if i move the control to spin it drains all the water and then just sits there. does this still sound liek the water level? if so how can i check that sensor’s operation.

Thankyou once again for your help

regards

[tona955]

Re: Candy Sprint 1200 HELP

Hi All,

I have just done a test on the Candy and this is what it is doing….

Goes through the cycles Ok fills up and also drains BUT the drum will not rotate on any program.
Reading the other like posts suggest that it might be the bushes? if so where do these go the motor is under the drum are they the standard bushes you get on the comutator?
Any info on how to replace these would be appreciated.

Thanks

[Author]

Posts