Forum Replies Created
-
Posts
-
Re: Fridge Freezer with plumbed water
johnsdad wrote:check out fisher & paykel, they’ve got what you’re specifying
Thanks, I did look at there models as we have a dishdrawer system and love their stuff. The fridges are very deep but i’m seeing if i could fit a E402BRXFDU in, looks like a nice FF.
Thanks for the advice.
Re: E20 on Zanussi WJS1265W during drying cycle
I think we need pictures and an idiots’s guide. Don’t wanna mess it up !
Re: E20 on Zanussi WJS1265W during drying cycle
Cheers will try it. Think E20 is a generic code that is often a pump fault but when the error is only during the drying cycle then it indicates something else. Hope i’m right !
Re: E20 on Zanussi WJS1265W during drying cycle
I have the same problem on my ZWD1681W and suspect as it’s just the drying cycle that gives the error that it’s a blocked condenser unit.
I can see it from underneath but have no idea how to remove it to clean it.
I suspect you have the same problem.
Re: Servis M7665S fridge warm
Hi, it was a gurgling sound. I switched it off for an hour last night then checked it again this morning and it’s all working fine ! Will leave it for a few days and if it’s still ok will just forget about it. Any ideas what it could have been ?
Re: Servis M7665S fridge warm
Serial is 20024817159-038077061-03. The lhs inside wall is warm to touch and there is a slight gurgling noise from the inside. Thanks.
Re: Zanussi WJS-1397W not draining and a funny noise
Thanks for the info, fitted the new pump and the noise is gone. However another fault ha shown up and i’m not sure if i’ve caused it. The machine seems to get stuck mid cycle, i.e it stops with the drum full of water or continually slow spins. I think the program selector section is sticking. I’m wondering if some water got in when i had the machine in bits. Any suggestions ? Is this bit expensive to replace ?
