Forum Replies Created
-
Posts
-
Re: AQGMD149 can not fill with water
It’s now on with another load! Is there such a thing as an intermittent fault on the module??
Re: AQGMD149 can not fill with water
It’s done 2 colourfast washes now since in went down. It seems to take a long time to start to fill with water though and seems to run on with 1min on the display for an equal amount of time as if there is a timing issue.
Anyone any ideas?
Re: AQGMD149 can not fill with water
I just Kept switching on and off at the socket and machine. Eventually it started. It only done the 1 load before starting it’s antics again! So no further forward really
Re: AQGMD149 can not fill with water
Quick update. I’ve finally got it to start a cycle. It’s filled with water and agitating as I type. Hopefully it will finish. I’ll know in 43mins.
Re: AQGMD149 can not fill with water
Just tried the machine on with the delay timer set to an hour and after 9 mins it displayed machine blocked. How could it know when it wasn’t meant to be doing anything?
Re: AQGMD149 can not fill with water
I don’t think the machine was registered with hotpoint when it was new so I’m not sure if the parts warranty would stand.
The machine is only 4 years old maximum.
Re: AQGMD149 can not fill with water
I’ve had a look at the motor and all looks well, no smell either. It appears to be brushless? I’m thinking PCB. have you any idea of cost of these?
Re: AQGMD149 can not fill with water
Is there any way of testing individual components? I’ve tested just about everything for Continuity and nothing seems open circuit but as I have no tolerances to compare with I can’t be sure. Is there any sort of service/diagnostic manual for this model?
Re: AQGMD149 can not fill with water
Have you any idea what could cause the F1 error? I have checked all the connections and all seem good. I found the live wire for the dryer heater to have rubbed through but have taped that up.
Re: AQGMD149 can not fill with water
Is there a procedure for re setting the pressure switch? I didn’t realise laying it down could do any harm, but I’ve learned now.
