[Tym]

Re: WF240 stuck on wash

Thanks Guys. All sorted. Heating element arrived yesterday – took 10 mins to fit. No fight encountered! Undoing the nut to half its length, so it stays on the thread, then pushing hard with the shaft of a hammer released the pressure enough – it just prized out easily.

Ran a short load and working perfectly again.

Many thanks to all who helped.

[Tym]

Re: WF240 stuck on wash

I presume you mean the one in the middle that’s the earth terminal? (this bit’s all new to me!)

[Tym]

Re: WF240 stuck on wash

I’ve found the heater ok, disconnected it and had the multimeter across the green/blue and green/brown terminals which I presume are the ones to test – Nothing. Tried each of these against earth too and still nothing.

I’m guessing that this is the way to test it?

http://www.trackmego.net/img_0327.jpg

This shows my heater.

Question is – how on earth does it come off!!!!

[Tym]

Re: WF240 stuck on wash

Thanks hotpnt

I’ve got the message about the plug! 😆

[Tym]

Re: WF240 stuck on wash

Thanks – can you point me in the right direction of the heater? photo perhaps?? I have multimeter so can test – just need to find it! Is this accessible through the “hatch” at the back?

[Author]

Posts