[Vladd]

Re: Bosch motor problem

You got an e-mail to post to Martin ?

[Vladd]

Re: Neff N4263NO/02 Induction hob error Er2

E2 code is listed as fault in the ventilator. 1)Check wiring 2) Check fan/ventilator 3) Replace right ELIN ???? Main PCB board.

Hope this helps.

[Vladd]

Re: WTL6304GB/02 8209200086

Which light is it that flashes ? If you have an e-mail i’ll try sending the manual.

[Vladd]

Re: Diplomat ADP8234 Dishwasher

According to Mfidentifier

E4 Temperature sensor disconnected
This alarm arises when the machine is switched on if the temperature sensor is disconnected. This
happens only rarely during normal use: it is more likely as a result of previous maintenance work
involving the wiring, for example, replacement of the electronic board or the detergent dispenser.
Run the following checks to resolve the problem:

[Vladd]

Re: Bosch WFF2001GB/01

The fault indicated is a water fill time out according to bosch technical site.

[Vladd]

Re: Hotpoint Tumble Dryer

Sorry,daft of me.

Model CTD40P
Serial number 601240007
Product code 95313600000

Anyone ???

[Vladd]

Worth a try, t

thanks for the pointer

[Vladd]

Yes it does.

Thanks for the help anyway.

Has anyone else seen this problem before

[Vladd]

We have the TDS off-line discs for the test programs. Unfortunatly the machine runs through the diognostic without bringing up a fault !!!
PNC no is 916716804/00

[Vladd]

Is that the correct model ???
I can find a SG06ECSWQL/XEU on the samsung site but not the model you have quoted.

[Vladd]

You can run a test program on it.
Switch off, press and hold the super freeze button and switch it back on holding the super freeze until P0 is displayed.
P0 starts a defrost phase
P1 FC fan
P2 RC fan
P3 Drain heater switched on
P4 Defrost heater switched on
P5 RC heater switched on
P6 Compressor runs
P7 RCS temp displayed
P8 No function
P9 FCES temperature displayed
P10 Status of FC door

Hope this helps

[Author]

Posts