[washermad]

Re: Hotpoint AQUARIUS WML560 diagnosing error

Ok thanks, will try that.

I turned it off for a while and now it is back on and has returned to the original F03 error. Seems to be somewhere between the 2 errors…

[washermad]

Re: Hotpoint AQUARIUS WML560 diagnosing error

Hi again,

I completely removed the water heater and then the NTC from the heater. I put everything back together and switched it on.

Now when I run a program it does nothing for a while (as before), but then the light which indicates the stage it is on, spin for example, stops being lit.

All the same lights as before begin flashing Super wash, extra rinse, mini load, reduced creases, and start/pause’ but this time only the door lock on the 5 indicator error lights remains lit. The washing machine emits a noise (which is also new) like it is trying to do something, sounds like a motor, but it does nothing.

Am I correct in thinking that this means it is now fault code f01 and is more than likely the PCB that is dead?

Thanks

[washermad]

Re: Hotpoint AQUARIUS WML560 diagnosing error

Hi,

Thanks for confirming! I’ll start tinkering.

[washermad]

Re: Hotpoint AQUARIUS WML560 diagnosing error

Hi,

Thanks very much for getting back to me. Just to check, there are 6 lights including the key lock symbol. Do all of these count towards the error code e.g. it represents error 3 as you suggest or does the lock door symbol not count and therefore only error light 1 is relevant?

I just wanted to double check before I cause any (more) damage as you state five vertical lights.

Thanks again

[Author]

Posts