Forum Replies Created
-
Posts
-
Re: Beko DW450 not working – all lights solid
A little bit late for a reply, but it may help a few others as I searched for the answer to this myself and couldn’t find one.
The fixed my dishwasher by replacing the main module – part number F335:
http://www.buyspares.co.uk/beko/dw450-7 … ref=479878
Make sure you unplug everything and then turn the machine on with it still unplugged to discharge it before beginning work.
Remove the door panel by removing the screws around the rim on the inside of the door. You’ll also need to remove the metal door cover, again this is done by removing the screws around the rim on the inside of the door. It’s difficult to tell them apart from the heads, but the outer two at the top and middle two on the sides hold on the door panel and the rest hold on the metal cover, so be sure to remove them in this order. To be sure, if you unscrew a short screw, put it back in until you find the four that hold on the door panel.
Once the door and metal cover is off you’ll notice a grey housing just under the control panel. You need to unclip this to get to the control board. Once exposed remove all the connections to the board and unclip it from the housing. Replace with the new one and connect the cables. There’s a tricky connection in the bottom right hand corner of the board. The board has two slots, but the connection has one ridge, so it can fit in to either slot. I put it in the top one and it worked fine.
You then just need to put everything back in reverse. It took me around 20 minutes in total, most of which was messing around with getting the door on and off.
Good luck!
