[Wheel]

Re: F&P Smartdrive 501 no water fill

Yes, James I confess now ,that I did spray Electronic components spray(CRC) , quick evaporating spray, on the back of the display board, where I thought I saw some burn marks!

Thanks for your other advice and I will try that trick and let you know results.

Wheel

[Wheel]

Re: F&P Smartdrive 501 no water fill

Could anyone tell me where can I get a service manual (if at all possible) for this machine?
I am in Auckland, NZ
Thanks
Wheel

[Wheel]

Re: F&P Smartdrive 501 no water fill

Today I bought the unit and replaced. Unfortunately the response is no different.
It goes through self test, all LEDs light up sequentially then goes off. No further response when POWER is pressed.
I am beginning to suspect the 2 micro switches- one on the display board (does it get activated when the lid is open?) – the other in the right hand side beside motor control board, which may have dislocated when plugs were pulled. They both click alright, I checked one of them with AVO meter, it works fine.
Does any one have a picture of top right corner, beneath display board?
Just to check whether I have mounted right way.
Thanks
Wheel

[Wheel]

Re: F&P Smartdrive 501 no water fill

Thanks very much, Penguin!
I will go buy one tomorrow , Monday.
Will let you know my results.
BTW, is it the one behind the front push buttons panel?

Regards,
Wheel

[Author]

Posts