Forum Replies Created
-
Posts
-
Re: F&P708F, Problem resolved now code 11 0r 224? 00001
Hi,
Yes, i did read the post you refer to.
And, i did drain the machine fully, all over the floor, as I suspected the pump and pulled it out.
I also removed the hose off the pressure switch and blew down the hose to make sure it was clear.
One point, after replacing valve i had a problem with the hot solenoid not turning off. this was a drop of water right on the PCB at the hot solenoid wire solder tab.
After removing moisture the thing worked OK. But, the washer did more water than it should when this happened and was restarted, so pressure switch may have “got confused”??
I have tried holding start and powering on to reset, but code is still there, despite this the machine appearing to function correctly, have done 3 loads of washing all A OK.
The water pump and hose blowing was afer the hot solenoid episode.
Cheers
William
