[woods2012]

Re: Zanussi ZWG6165Z PCB

Nope its burnt to a crisp lol i can email a photo of the PCB if you have a email address

[woods2012]

Re: Zanussi ZWG6165Z PCB

Thanks would you know what to replace it with??

[woods2012]

Re: Large whirlpool dryer

If you ring whirlpool they supply the parts at trade prices and ship fast, easy to work on just take drum out, and you can accesses the all parts very easy , if you force the pulley to stay open it makes the belt slip off with ease hope this helps

[woods2012]

Re: MIELE PART: MLE1880308 Dryer motor needed

thanks thats a great help 🙂

[woods2012]

Re: MIELE PART: MLE1880308 Dryer motor needed

thanks for the info i will drop him a email

[woods2012]

Re: Amica AWM712D won’t start door locked

If your sure there is no blockage and have split the pump, you can take the pump off and check it connect 240v to the pump and test it but please be careful when doing this
as the pump could be dead, to check the water valves you need a multimeter and it should read above 3, on continuity. the door should open after a few mins with the power turned off but im not sure some washing machines don’t open until there is no water in the drum has it still got water in the drum? if it has drain it off and see what happens is the PCB ok worth checking to see if anything is blown, hope this helps 🙂

[woods2012]

Re: Zanussi FX1365W

Does the new pump work? can you test it off the machine with 240 mains but be careful i would check the PCB tracks on PCB could have blown

hope this helps

[woods2012]

Re: Amica AWM712D won’t start door locked

Error code 11 is

‘Washing machine has detected an overfill of water’

Check drain pump for blockage or obstruction
Check drain hose for blockage or obstruction
Check drain pump
Check fill valve is not jammed open or leaking
Check electronic control module

Does it power up? Spin? Pump out? Can you send more info

hope this helps

[woods2012]

Re: Indesit wixxe127 keeps tripping rcd

Hi, could be motor carbons make sure you check both of them,damp in motor or motor armature fault? try fitting a used/new motor to test it checking heater element just to be on safe side might be worth a try hope this helps

[Author]

Posts