Forum Replies Created
-
Posts
-
Re: NEFF dishwasher not draining – followed suggestions on f
Sorry for the slow response, I was expecting an email alert to tell me someone had posted a reply but for some reason it didn’t. Anyway, thanks to all for their replies and advice. Particular thanks too Penguin45 and BS-MAN. By copy Penguin-45, would you mind elaborating on
“if you were to follow the three strakes in the bottom of the sump through to the outside, you’d find the drain pump and drain hose; that’s the place to start”
Can you confirm what you mean by strakes,? do I need to remove the wsaher from it’s position, if so , do you have any idea how to do this?
Thanks again
Re: Creda 1200 Cascade Ecowash not spinning
Hi, just checked, it’s a Model Number: 17345e and the Serial Number is : 11181071. The washer came with a flat I’d bought and I had never even switched it on so have no idea how old it is but it does look in good nick.
I’ve now found and downloaded the user manual from the website which is a great help.
Thanks again
Will
Re: Creda 1200 Cascade Ecowash not spinning
Thanks guys for the quick response, fantastic service! I’ll scrap the 1150 and confirm the model number of the 1200 and post later. Will take advice re Electrical check, also re manual, It’s for my mother, she’s getting on a bit and hasn’t a clue how to work it so a user manual is all that’s required.
Thanks again
Will
Re: Creda 1200 Cascade Ecowash not spinning
Sorry to jump in on this thread however wonder if you could help me?
My mothers washer (CREDA 1150) started making a ‘loud noise’ when spinning. I took off the lid and back to have a look and could see nothing untoward however when manually spinning the drum it’s noisy and making a slight grinding noise and suspect a bearing may have gone. Is this worth fixing or should I scrap it?
Fortunately she’s got a spare machine, it’s a Creda 1200 Cascade Washer Dryer ecowash series, I can’t see what the Model number is. This has been in her garage for some time and was believed to be working however when I plugged it in after a few minutes there was a bang and the fuse had blown. I took off the top and had a look inside but could see no obvious signs of electrical fault, i.e. smoke, burning etc. and so suspect it may just be because of condensation/moisture within the washer, is this feasible? I have since ran a quick test wash succesfully with no futher incident however with the lid off noticed that arcing or sparking can be seen within the motor when the drum is turning is this normal?
Finally I’ve tried to find a manual online without success, the website http://www.theservicecentre.co.uk only appears to refer to model numbers which I can’t determine, does anyone know what this may be?
Many thanks in advance
Will
