Forum Replies Created
-
AuthorPosts
-
Zanussi25
Participantelectrofix wrote: look for resistor type ac03000001000jaccs
3 watts 100 ohm the above number means its a safety fusible type
found on ebay
or
or
as for the chip would need the number off the top of it. Often get them off ebay but mouser may have but just beware as am not sure of p&p or any min charges
dave1212 lnk 305gn00928c
Zanussi25
Participantelectrofix wrote:ok look at the pic
check the resistor (yellow) expecting about 100 ohms
if thats gone you will need a new fusible resistor and the chip (red)
thats most likely whats failed
Dave
Took the PCB out and I’m getting no reading off that resistor in yellow, set multimeter too 200 ohms. If I need them parts, is there a good website to purchase them?
Zanussi25
Participantelectrofix wrote: need to see a good picture of the electronic panel inside
it is probably the board power supply and if i saw what things look like can probably tell you what to test
Dave
This is it here, it won’t let me upload an image due to file size
-
AuthorPosts
