- This topic has 97 replies, 16 voices, and was last updated 20 years, 6 months ago by
.
-
Posts
-
I’ve not used it Chris and I don’t have a manual to hand here, but remind me in the am and I’ll check for you. 😕
But anyway, what you doing answering the phone on a Sunday?
K.
Re: Questions
We have a meeting on Wednesday with the right people, it’s on the agenda. More when we know.
Kevin
Re: Questions
Not sure if I made a mistake due to being busy, ( or old and dozy) first install a week ago model number noted as a CI555WH. today I am sure the machine had model number 8665CT, or have I misread the rating plate?
Re: Questions
Another mystery solved then. 😉
CI555WH is the model, 06-100527-01 is the serial and yes, it is IPX4 rated for use in bathrooms etc.
K.
Re: Questions
I have just had time to have a proper read of the user manual. I have been very busy ( not complaining). I come back to something a customer asked me about that I could not answer at the time regarding Rinse Hold.
I have gone through the manual several times and the only mention I can find of Rinse Hold is on pages #10 & #16. However, I can find no mention of how to select Rinse Hold or indeed find a Rinse Hold button. Is it possible that when selecting No Spin that you are selecting Rinse Hold or will the machine just drain out without spinning.
Re: Questions
Yes Jim, I think that the “No Spin” serves as a rinse-hold in effect but without the suspension in water.
TBH I can’t say I’m bothered undully as I don’t know one customer that ever used the function but I know plenty that complained about it. 😉
K.
Re: Questions
Wouldn’t the schematic wiring diagram and programme sequence chart not show if it had a rinse hold facility or not? As Ken says, no-one uses it these days so probably not part of the ISE machine either 😉
Re: Questions
A change to the manual is definately needed then, page 16 ‘troubleshooting’ says,
Pump does not drain
Check Rinse Hold button has not been selected in error.Perhaps I need to take some Tipex with me on installation calls and erase this error to save any confusion.
Re: Questions
Martin wrote:Wouldn’t the schematic wiring diagram and programme sequence chart not show if it had a rinse hold facility or not? As Ken says, no-one uses it these days so probably not part of the ISE machine either 😉
It would if we had one, 😉
like Ken I only know of one or two people that actually use this, and I have not come across one customer round that has ever used time delay either.
Re: Questions
Page 16 of the user instructions :- “Fabric Softener Indicator Light on the program follower”…….Does it have one? Which one is it then?
Re: Questions
Ken, can you take a couple of shots of the control panel and email to Martin, please
Thanks
Kevin
PS Martin, will call you pm today.
- You must be logged in to reply to this topic.