[1Dude]

Re: Ariston Margherita A1635

YES its back up and running, I found the problem on the main board, the solder around the relay had burnt away it was almost a dry joint with hardly any solder around it, so I got my iron out and gave it a good wet joint and then put it back together, and then connected my meter to the element and after about 4 mins in to the cycle the element powered up

Thanks odom for your help

[1Dude]

Re: Ariston Margherita A1635

Just done some more testing and found that element is not getting any power ! also there is no resistance across the sensor ! is this the the problem ?

[1Dude]

Re: Ariston Margherita A1635

Hi i am back and irs nearly 2 months and its gone wrong again, the problem this time is the programmer when put on a was stays on the programe and does not move off it does the cycle over and over again but i did notice the water is not getting hot, so i moved the temp to zero and its does the complete cycle, so i now suspect the heater element has gone, i have taken it out of the machine and have put a meter a cross the termanals and get 31 ohms is this correct ? what should i be getting

Thanks in advance

Clive

[1Dude]

Re: Ariston Margherita A1635

Ok i am trying to find the correct brushes for this machine, it does have a Indesco motor fitted, but looking at the pics of the brushes 047317 the location pips are not in the same position ! they look more like the pic of the 105214.

anyone help ?

[1Dude]

Re: Ariston Margherita A1635

Thanks for the info helo_75
I cleaned the pump out I did find a couple of coins, but it still did not work, I have taken the brushes out, looks like one got stuck, cleaned the dust out with some electrical cleaning spray, ALL OK NOW, but i will order some new brushes

Thanks Again

[1Dude]

Re: Ariston Margherita A1635

Hi i noticed the timer on my machine turning, now it wont start, after reset i get 4 or five flashes, it flashes so quick, anyone could give me the fault code for these flashes it would be most helpfull

[Author]

Posts