Forum Replies Created
-
Posts
-
Re: Bosch WFF2000 spin problem
I ended up stripping the machine right down, and removing the drum. Everything seemed in order, until I started the rebuild, and noticed that the clips that hold the front panel, and weight on to the drum, were loose. I bent them to make sure they held the front plate tight, and haven’t had a problem since! Thanks to everyone who responded to my post. 😀
Re: Bosch WFF2000 spin problem
Well I replaced both shock absorbers and it’s slightly better but not fixed. The spin is still noisy! It looks like the drum is spinning slightly off centre at full speed. The machine had a new drum and spindle + bearing just over a year ago, so I would be surprised if these had failed. Any other ideas? What about the springs that the drum hangs from?
Re: Bosch WFF2000 spin problem
Thanks Phil. I replaced the bearing about a year ago, so I was hoping it wasn’t going to be that. Luckily, the bearing was quiet, but the drum bounced all over the place. Cheers, Adrian
Re: Hygena deluxe electric cooker hob switch problem
Hello Dave
Thanks for responding. Model number on the cooker box is AHY3120 and on the seperate hob APM1220. I solved the hob switch problem by pulling off the plastic knob and then tightening the brass washer, which had fallen off the base of the switch. However the red led which indicates whether one of the hot plates is on, works intermittantly. How do I access this light?Cheers
Adrian
