[adv]

i think is what i am on about in my last new topic ,what do you mean pressostat?anyone got a picture of one ?

[adv]

electrofix wrote: there should be a stat kit for it but the hotpoint spares site is incomplete on this model

email Aswo or Qualtex all the commercial codes and serials and get them to request info from hotpoint or email the hotpoint spares site

Dave

to much hassle pal . cabt be arsed with it anymore . all just have to give the cx some money back …

[adv]

i meant the heater no reset on stats crap that:mad:

[adv]

ok cheers am not getting involved in the boards to much hassle .. the boards are good .. not that good if cant reset the stats .. have to get another heater as well .. heap of junk if ask me

[adv]

Would a faulty ntc cause the states to pop on heater no reset hole on the states ..ffs :mad:might just pass on to.hotpoint pain in erse 😡

[adv]

really that would be good saving having to buy another heater ..yes the same make geniune hotpoint .. do you know any thing about this front vent state causing problems .. ? its not listed on connect but my parts guy has them .. is it possible you could put a diagram up of where it is and how to get to it ?

[adv]

hi dave the states dont have a reset button them.or is there a trick to resetting one ?the motor sounds normal .. my parts guy says there is a state at the front .. wonder if that was faulty it would cause this ? he then went on to mention the pcb :mad:..anyone any more info on it ?

[adv]

he said it has got a modern rcd consumer unit :rolleyes: thanks for help again much appreciated ..;)

[adv]

well went back to this took wire off stat still heating up .took both wires off still heated up .. thought i was losing my mind .. :confused: took back off was just about to right it off . then noticed the double earth was on the neutral side of the element wtf ..:mad: customer said never been looked at before . luckily we both never got fried especially him been in for 15 years 😮

[adv]

Ok.all try that

[adv]

if took one of wires of the thermostat it surely couldnt heat up ? that would be impossible not ?:rolleyes:

[adv]

hi mate am not that great with wiring diagrams tbh .. the old stat is always showing continuiaty .. and it doesnt click at all when turn it .. but is that because its faulty ? what do you think it is mate ?no one else has been at it ,, he said

[adv]

customer says original one never really made a clicking noise when turned it up or down :rolleyes: mmmm

[adv]

electrofix wrote:

no

tub is on a cantelever system. the outer tub is fixed and the inner tub moves. so there is a flexible rubber at the back like a door boot
see pics and look at sevice manual link above

Dave

deary me looks a nightmare 😮

[adv]

water in base maby :rolleyes:

[Author]

Posts