ali_g12

Forum Replies Created

Viewing 3 posts - 31 through 33 (of 33 total)
1 2 3
  • Author
    Posts
  • June 17, 2020 at 4:42 pm in reply to: Beko WDR7543121W Replaced PCB now double beep and E23 error #466546
    ali_g12
    Participant

    I think it was a software issue. The manufacturer’s service agents came out under customer’s insurance and replaced the PCB (again) but in reality probably just programmed it. Let me know if you get to the bottom of it.

    February 20, 2020 at 12:50 pm in reply to: Beko WDR7543121W Replaced PCB now double beep and E23 error #466544
    ali_g12
    Participant

    kaibart wrote:I would check the wiring on the dryer side if that’s ok I would check the wash heater

    Checked wiring from dryer element, heater element and door lock all the way back tot he connectors on the board. They’re all OK. Ran machine on dry – that’s working fine. Both elements have continuity and not leaking to earth.

    As before, I can run a cycle outside test mode only if I have come out of test mode with the door lock still engaged. If I just try and run the cycle without having been in test mode (and engaging the door lock with a test) then I get the double beep.

    Anymore ideas? Could it be a software issue? Anyone got a service manual?

    February 17, 2020 at 6:52 pm in reply to: Beko WDR7543121W Replaced PCB now double beep and E23 error #466542
    ali_g12
    Participant

    kaibart wrote:Error 23 is a door switch (white secondary) faulty if this helps

    Thanks for the input. I had a feeling it was door lock related. It’s strange that the door will lock after having been in diagnostic mode. I know the lock itself is OK as I’ve replaced it. Is it a case of clearing the fault code from memory after replacing the PCB? Or do you think it is a wiring harness issue?

  • Author
    Posts
Viewing 3 posts - 31 through 33 (of 33 total)
1 2 3