Alilou

Forum Replies Created

Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • April 7, 2020 at 8:00 pm in reply to: Sms50t02gb #467780
    Alilou
    Participant

    Hi Dave
    Thanks for your prompt reply.
    It was no continuity between poles!
    displaying O

    April 7, 2020 at 6:16 pm in reply to: Sms50t02gb #467778
    Alilou
    Participant

    Hi Dave
    Not heating the water

    April 1, 2020 at 8:58 pm in reply to: Bosch SGS45E62GB/52. FD 8505000597 #467484
    Alilou
    Participant

    Thank you Dave
    Much appreciated

    Fred

    April 1, 2020 at 3:10 pm in reply to: Bosch SGS45E62GB/52. FD 8505000597 #467482
    Alilou
    Participant

    Afternoon Dave
    I hope you are keeping well.
    where can I please find the timer?
    OR
    Do I need to replace the followings:
    The water heating element
    Turbidity sensor
    NTC sensor
    Please advise?
    Regards
    Fred

    March 31, 2020 at 8:40 pm in reply to: Bosch SGS45E62GB/52. FD 8505000597 #467481
    Alilou
    Participant

    Thank you very much Dave
    i will check it out.
    Regards
    Fred

    March 31, 2020 at 6:22 pm in reply to: Bosch SGS45E62GB/52. FD 8505000597 #467479
    Alilou
    Participant

    Run a quick cycle @45
    dishes were cold!!
    should I try an intensive @70 to compare
    or it’s irrelevant!!
    Regards
    Fred

    March 31, 2020 at 4:21 pm in reply to: Bosch SGS45E62GB/52. FD 8505000597 #467477
    Alilou
    Participant

    After the “Drying”light goes off.
    ”check water”light comes on and stays on!!!!
    i am assuming towards end of cycle!!-
    Also noticed . Inside machine over mouldy!!
    Regards
    Fred

    March 31, 2020 at 12:39 pm in reply to: Bosch SGS45E62GB/52. FD 8505000597 #467475
    Alilou
    Participant

    Hi Dave
    Thanks very much indeed for your prompt reply.
    Just to give you more clues. “Water check” stay on until the end of cycle!!
    monitored the matrix on two occasions and it’s not full of water? Is this related to the problem?
    Many thanks for your massive help!
    Regards
    Fred

  • Author
    Posts
Viewing 8 posts - 1 through 8 (of 8 total)