[alzspb]

Re: IGNIS ADL 334 – fill-in then drain water in cycle

Thank You to all 🙂 Problem is solved.

Reason of malfunction was NON CORRECT setting-up of machine on the floor level. Dishwasher has a tilt about 4cm to down of left/door corner. In result, in time of working water throw the left green plastic tube flow to lower pallet. “Aquastop” was activated and machine stopped blinking with start light.

After flushing lower pallet machine start cleanse salt-modul fill-in then drain water in cycle. After 10-30 min of this NORMAL washing was be contunued.

After correcting level of machine all working FINE 🙂

Thank you from Russia for help.

PS: FC “ZENIT” – Champion! 🙂 FC from our city.

[alzspb]

Re: IGNIS ADL 334 – fill-in then drain water in cycle

This is sketch of control panel my machine:

I have only one buttton and mode selector lever.

[alzspb]

Re: Russia calling!

Hi!

I`m that guy from Russia, which asked Martin abouе ARISTON AML 105 EX.

Now i have a error codes for Merloni wahing machines.

In my machines it must be F03.

I checked resistance of main thermo sensor – it`s about 23-25kOm in 16C temperature. BUT on main board contacts 11 and 12 ( J8 ) resistance is about 10k0m. I look on this and see what pin 12 of J8 connect directly on EVO2 chip. Also i have burned J10 between pins 2/3 and pins 4/5. This connector ALSO directly connect to chip.

May be on burning J10 time chip was damaged?

This is picture of my dead bastard 🙂

[Author]

Posts