[Andycplumb]

Re: Blomberg 1301 ABB – no power

Thanks again penguin ,
Ive fitted new door interlock ,I recieved it yesterday ,machine is running fine ,lets hope it lasts another 7 years ❗ ❗ 😆

[Andycplumb]

Re: Blomberg 1301 ABB – no power

Thanks Penguin Ive taken your advice and purchased a door lock
Iwill replace the old one as soon as I recieve it
Thanks for sharing your knowledge Andy 🙂

[Andycplumb]

Re: Blomberg 1301 ABB – no power

I have the same machine Blomberg 1301 ABB ,
and I have had the timer pcb tracks blown 3 times now (over 4 months)
Each time I have taken the timer module out myself & had it repaired
at an electrical repair shop £10.00 each time & checked for obvious
reasons loose wires earths etc ,And after reading the posts on this forum
from experienced repairmen .
I think its down to water getting in through gaps behind the powder
dispenser So after taking dispenser out ,I have sealed all gaps with
silicon sealant ,so far so good but I will let you know if this has cured it
for good in a few months .
I have had this machine 7 years now with no previous problems
good luck with yours

[Author]

Posts