Forum Replies Created
-
Posts
-
Re: Xanussi ZDF 221 Filing Problem
Hi
Just an update.
I have removed the left hand case panel and exposed the inlet management system. I have checked the pressure from the cold feed. This comes directly from the main and the pressure going into the inlet valve is very good. I have disconnected the hose to the inlet system to see what kind of pressure is there and it can only be described as a trickle. The filter in the inlet valve is clean and clear. I can see water travelling through the clear plastic inlet system but nowhere near enough to fill the machine in the time allowed. In fact, when I open the door immediately after the fill has completed, the machine has taken on some water but I would guess just under half te amount it should. If I top up with water from a kettle, the cylcle continues to its wash programme. If I don’t top it up, the machine drains and then I get the error lights for water not being taken in.
Does this point to the inlet valve being the problem rather than pressure switches or controller?
Any help appreciated.
Thank you
