banana37

Forum Replies Created

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • in reply to: Hoover acm 15 washing machine spin problem #393031
    banana37
    Participant

    Re: Hoover acm 15 washing machine spin problem

    hi martin
    thanks will check that i have checked the filter it is clean as a whistle. the only fault is with the drain pump it makes a noise when running but it has been like that for ages and the machine ran ok… makes me wonder if the manufactors program
    a shut down seqence into the eprom to make them go out of sync so you have to buy a new machine otherwise they would never sell them if they ran for years i take it you mean the magnet on the motor shaft and not the outer black ring on the tacho

    thanks Ian

    in reply to: Hoover acm 15 washing machine spin problem #393028
    banana37
    Participant

    Re: Hoover acm 15 washing machine spin problem

    fitted new brushes but still not working the machine seems to not want to go into the rinse cycle and take in water or go into spin mode just empties the water from the short wash cycle then spins clockwise then anti clock for about 10/15 seconds each way then the drain pump kicks in empties the water and keeps rotating the drum as above for about 2/3 mins with the drain pump running then shut off. the red main indicator light stays on
    seems like trouble in a tin box bring back the good old mandle rollers and dolly tub

    in reply to: Hoover acm 15 washing machine spin problem #393027
    banana37
    Participant

    Re: Hoover acm 15 washing machine spin problem

    sorry to sound stupid but what do you mean heater down to earth?
    the heater is heating the water up ok, and the earth wire is connected to the nut shaft on the heater via the nut and washer on the end of the earth wire

    thanks

    in reply to: Hoover acm 15 washing machine spin problem #393024
    banana37
    Participant

    Re: Hoover acm 15 washing machine spin problem

    Thanks Martin for the reply but if it were the brushes
    would the motor not turn at all or try and wash cycle?
    thanks Ian
    email black arrow37@virginmedia.com

Viewing 4 posts - 1 through 4 (of 4 total)