Forum Replies Created
-
Posts
-
electrofix wrote:i think all you need to tell them is it wont fill
also send the service numbers off the label inside the door in case they need it
dave
perfect thank you dave for all your assistance
Thank you for that info they repair only on my module so now its a question of sending off with fault code ( not sure what that was)
Have removed the module ARC2.3PH STRI P P50+EVC+ED5 Part number:J00278851 no obvious signs of damage everything looks as it should do.
Theres a code :215012744000 and fw1:11.01.13, fw2;1.8.10, fw3:08.01.02.
I have found the exact match for this on hotpoint web site and on ebay but the ebay 1 says its for a WMXTF942PUKR. the one on hotpoint says module only but needs programming.
question is can i safely put the ebay one in the wrong machine most of the programs the same with a few exceptions. Or can i send the module away to be programmed for our machine. either way i dont want to spend 85 quid for a new part unless 100{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} nothing else will workwith the booklet for the machine it says the parts are guaranteed for 10 years wonder if that would cover the main board.
today i replaced the pressure switch after having talked to a repair man – – He said to check and replace the pressure switch as that sends a signal to the inlet sensor to open or close the water when drums full. That has done nothing nore has the new inlet solenoid block. I dont know what else to check please please help.
