[blackduck]

Re: fisher paykel has no power

bigsmokepiker wrote:The Pump in this Model forms part of the power circuit
It may well be the pump If not it will be The Main PCB (Motor Controller)

pump is new as is power board…………the board behind the buttons. Im wondering does this machine has a reset button? It was working fine,halfway through spin cycle and I pressed the power button instead of the pause button……….I have unplugged it and replugged it and turned it on but still no lights………..could I have dameaged it by pressing the power button while it was spinning?

thanks mate
Cher

[blackduck]

Re: fisher paykel has no power

iadom wrote:Moved you to the Oz forum Cher. 😉 You will still be likely to get an answer from your favourite feathered friend in here. 8)

Thankyou…………………..merry xmas

[blackduck]

Re: fisher and paykel error 9?

Ok followed your instuctions and all is well. Thanks Penguin your a bloody legend mate
Cheryl

[blackduck]

Re: GW711 error code 9 (machine size)

Thanks Penguin
hmmm was sent the instuctions on how to reset with the board,thought I followed correctly. Will do it again with your instuctions. I have contacted f&p and asked for a list of error codes. heres hoping
Cheryl

[blackduck]

Re: help for diagnostic mode

Thankyou so much for your help
Cheers

[blackduck]

Re: help for diagnostic mode

Penguin45 wrote:STICKY.

Penguin45.

Ok here are the codes
2+4+8+16+32

I was told I needed a new computer board thing. I put one in and it blew up!!! Not good! put in another one and it washes and stops before it finishes draining. All lights go out, but will turn back on after a while.I think it might be the pump,but I wanted to check here first before I got a new one.
Thanks for any help.
Cheryl

[blackduck]

Re: help for diagnostic mode

Thankyou so very much…………and especially for giving me help so quickly. I will do as you ask and get back to you with the errors.

[Author]

Posts