[bu06nne]

Re: Zanussi Slim Integrated Dishwasher – ZDV12002FA

Ok thanks all the same. Do you know if the top part of that part serves any purpose other then to secure it to the machine?

[bu06nne]

Re: Zanussi Slim Integrated Dishwasher – ZDV12002FA

Thanks for investigating. So the bit that has fallen out the hole is the very top bit of part 145 that overhangs.

It’s still in the right position, just not sitting in the hole. Do you think it’s sealed from above or would this lead straight to the work surface? I have memories of seeing a plastic cap on the outside of the machine above where this hole was.

Cheers

[bu06nne]

Re: Zanussi Slim Integrated Dishwasher – ZDV12002FA

Here we go: 911 079 006 03

[bu06nne]

Re: Zanussi Slim Integrated Dishwasher – ZDV12002FA

Thanks – I’ll have a look at it when I get in this evening and report back.

[bu06nne]

Re: Zanussi Slim Integrated Dishwasher – ZDV12002FA

Hi, excuse my ignorance but what is a PNC?

It’s this one: http://www.zanussi.co.uk/products/dishwashing/built-in/fully_integrated/zdv12002fa/ if that helps.

Cheers

[bu06nne]

Re: Zanussi Slim Integrated Dishwasher – ZDV12002FA

Also just to clarify, the “arm” doesn’t spin round or anything, it runs along the back of the dishwasher and then along the top to the centre.

Thanks

[bu06nne]

Re: Zanussi Slim Integrated Dishwasher – ZDV12002FA

Thanks for the response. That looks like the thing that was on the outside of the dishwasher on the very top.

Does it need to be fixed – the arm is pretty rigid and is close to the correct position. My only concern is that where the arm previous was is a hole… I don’t really want water or steam going through the hole and out of the top of the machine. Do you know if it’s sealed on the otherside?

Cheers
Nick

[Author]

Posts