[Buildclean]

all connections fine.
If I take the pump out again is there a way to test it with a meter to see if it’s broken electrically?
Cheers
Peter

[Buildclean]

The machine runs the drain pump and then does nothing when it should be filling for around a minute and then we get an f78 again

[Buildclean]

ok so I have tested it and it does not have an open circuit. I get a reading of around 1900
I put the machine on its side, took off the base plate, disconnected the valve electrical load plug and then tested the feed plug that it connects to ie the one which is part of the machine loom and detected the following:
1. When the machine is plugged in and switched on (but no programme initiated) there IS power reaching the feed plug. (volt stick beeps)
2. If a program is started with the machine on its side, the drain pump fires up as normal and the power is switched off to the feed plug. The drain pump stops after about 15 secs or so but there is still no power to this plug
3. If the programme is cancelled and the machine is then turned off using the fascia button, the power returns to the feed plug after about 15secs

Just to let you know, we originally had an F78 error code and took the circulation pump out to clear the debris that was fouling the impeller. Once we put it all back together again we had the problem with the machine not filling. I’ve checked all the other plugs to make sure they have been put back correctly and they have.
Any help would be appreciated!

[Buildclean]

Thanks.
I’ll test that now.

[Author]

Posts