Forum Replies Created
-
Posts
-
Re: Hotpoint CTD85A problem
A1engineer wrote:Belt is on wrong, the pulley should go at back of belt, not enough tension to turn load the way u have it.
Good tip to fit pulley, loosen far away screw 1/2 way, fully remove one nearerst you.
Push pulley right back until it is past belt, fit belt around pulley and pull towards you until the clip on pulley locates at motor,
Refit screw and tighten both.Thanks mate that info was spot on re-fitted belt as you said to increase tension ….tip for re-fitting belt was fantastic too.
Total cost of repair £15.90 😛
Re: Hotpoint CTD85A problem
I have taken some pictures and done links because pictures are pretty big
Pic 1 is the jockey wheel i fitted
http://i454.photobucket.com/albums/qq26 … C_0150.jpgPic 2 The Motor and Capacitor
http://i454.photobucket.com/albums/qq26 … C_0153.jpgPic 3 Belt orientation
http://i454.photobucket.com/albums/qq26 … C_0152.jpgPic 4 The Whole Thing
http://i454.photobucket.com/albums/qq26 … C_0151.jpg
