CarlaOL

Forum Replies Created

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • CarlaOL
    Participant

    Re: AEG Oko-Lavamat 1271 VI Turbo – not completing cycle

    Hi
    4 years on the machine works fine. I never tried the drier again though and remember to put the dial on reset between each load…

    in reply to: AEG Oko-Lavamat 1271 VI Turbo – not completing cycle #312675
    CarlaOL
    Participant

    Re: AEG Oko-Lavamat 1271 VI Turbo – not completing cycle

    Hi

    this evening we tried to replicate the problem as we have someone coming tomorrow.

    we did a cold wash with the machine empty and it all worked fine

    then we did a 30 degree easycare wash with probably half a load and it worked again

    Should we cancel the person coming?

    Could I have over loaded the machine on saturday and it took a while to get back to normal?

    any ideas?

    thanks

    in reply to: AEG Oko-Lavamat 1271 VI Turbo – not completing cycle #312674
    CarlaOL
    Participant

    Re: AEG Oko-Lavamat 1271 VI Turbo – not completing cycle

    thanks, i have.
    the filter had a bit of gunk and hair which i have cleaned yesterday, but today the problem was still there

    in reply to: AEG Oko-Lavamat 1271 VI Turbo – not completing cycle #312672
    CarlaOL
    Participant

    Re: AEG Oko-Lavamat 1271 VI Turbo – not completing cycle

    Hi

    And just now after leaving it off at the mains overnight, i tried to do a 95 degree wash with vinegar and it worked ok (filling with water and spinning) for about 50 minutes (when i started the panel indicated 2.29 and the last I saw had 1.40

    Then it went back to 1 on the panel and the light is on wash. And the drum is full of water.

    I wonder if it stops when going to rinse.

    I am trying to do a pump out and it keeps pumping out a very small amount and then stopping and the panel goes from 5 to 1.

    Help!

Viewing 4 posts - 1 through 4 (of 4 total)