[cdm185]

Re: Ariston A1324UK – Dial clicking round, LED flashes 10 ti

OK I’m back again.

I am still getting an intermittent fault, which only seems to occur when I set the machine to come on at night…

So far I have:

1. Checked and cleaned filter at front of machine – OK
2. Checked pipe to pressure switch is clear – OK
3. Renewed pressure switch – not sure it was faulty
4. Renewed the heater element – the old part was low resistance to earth
5. Checked comm and brushes on motor – OK
6. Insulation tested the motor – OK
7. I have checked the control module as best I can and it appears to be OK

The intermittent fault is as before, program is aborted the dial start clicking and I get 10 flashing lights. The program always aborts during the wash cycle, and before the rinse cycle is reached.

Any ideas would be appreciated 😕

When I was checking the motor I took off the speed sensor attached to the non comm end of the machine. Not much too see because its a sealed unit, but there are strips of metal embeded into the plastic housing around the circumference – but they are not even. It looks like the housing has been worn away to reveal these, in fact in one area there is a small hole. Does anyone know if this is what it can be like, could this be the problem? Can these be purchased seperatley to the motor?

Thanks

[cdm185]

Re: Ariston A1324UK – Dial clicking round, LED flashes 10 ti

Will do, many thanks for the help again.

[cdm185]

Re: Ariston A1324UK – Dial clicking round, LED flashes 10 ti

Thanks for the info, much appreciated.

Serial No. of machine is 212037293 * 80280680000.

Existing switch seems to operate when pressurised. May be the contacts have tarnised due to it not being used for several weeks.

Think I will buy a new switch anyway, I’ve seen similiar one on website for about £20. I’ve looked through the UK whitegoods spares shop and they don’t seem to have one.

Thanks

🙂

[cdm185]

Re: Ariston A1324UK – Dial clicking round, LED flashes 10 ti

😥 Just when you think you’ve fixed it…after 5 washes the fault comes back again !!!

Could anyone confirm what fault is associated with 10 flashes on an Ariston A1324UK washer? I think its a pressure sensor? If so, is this the circular one located just under the top cover.

Ta

[Author]

Posts