[chrisgoodwin]

Re: F&P GW611 Problem

Brilliant! all good! – Thanks very much for all your help guys, I now have clean undies….. 😀

[chrisgoodwin]

Re: F&P GW611 Problem

Well I checked the valve, according to fastandpro! all good – so went back to electronics. Put new board in and the machine at least responds – BUT – now getting 1sec beep and 00001001. Checked the error diag and coming up all zero’s. – so assume this means ok…Balance ok, water to it…any other ideas?

Thanks guys…

[chrisgoodwin]

Re: F&P GW611 Problem

Thanks for all your advice guys! Will follow it up and splash out on a cold water valve then!….us yorkshiremen just dont like spending money! 😕

[chrisgoodwin]

Re: F&P GW611 Problem

Penguin45,

Thanks for your reply….

If I swap the hot and cold valves, will this create a different error, so I can narrow it down from electics/contol/valve?

Thanks again, from one ‘yorkshireman who defected’ to one who’s still there!

Chris

[Author]

Posts