[clocknut]

Re: Bosch

Result 😀 😀 I was quoted £240 for a new one Greg :rolls: the board is really well made 8)

John.

[clocknut]

Re: Bosch

Hi Greg problem solved I took the module out and there was a dry joint on one relay contact on the print which had been arcing I cleaned it up hard wired it reffited it and it is fine 😀 thanks for your help.

John.

[clocknut]

Re: Bosch

Thanks Greg it gets stuck for sure at the wash cycle if you do a mains reset it starts washing again so the module is not resetting it looks like it may be a module problem ❓ If I switch the mains off it should on the panel as well as the socket it should when both switched on be dead till the start switch is activated but it is remembering where it was ❗

Thanks,
John.

Tried a total off again this time it went to normal no light on untill you do a function ❗ ❗ ❗ sticks in wash but no spin if you select it pumps the water out ok before trying to spin.

[clocknut]

Re: Bosch

Update Greg as it stuck there on spin so we started a new wash where it stopped in the main wash 4 double clicks of a relay with a slight buzz between open and close then back into the wash again to repeat the 4 clicks etc stuck!

[clocknut]

Re: Bosch

I switched the machine back on Greg and it went straight to the rinse part of the cycle then just froze on the spin section! light on no motor function!

The heater is working fine Greg 😕

John.

[clocknut]

Re: Bosch

The motor is turning Greg thanks again, are we heading for a module fault ❓

[clocknut]

Re: Bosch

Hi Greg it measures 24.4 ohms so looks to be fine ❓

[clocknut]

Re: Bosch

Hi Greg thanks for the reply my wife has tried to go through a washing cycle I got the info wrong :rolls: it stays in the washing cycle and you can hear a relay clicking but returns to the washing cycle 😕

[Author]

Posts