[cloudhands]

Thanks for the help everyone have now identified and have ordered part it turned out to be a XOU489.

[cloudhands]

Re: White Knight Model 76aw condenser dryer

Thanks for the reply have now obtained a Manual on this m/c thanks to all.

[cloudhands]

Re: Indesit De73

Indesit DE73 (Dish Washer) Error Messages

5)a) Fault Code indications

Should a Fault occur in use, the LCD display will show a fault Code to indicate the area of the fault & on faults A01 to A05 inclusive all active settings are reset & all loads deactivated :

A01 = Acquastop operated due to leak / overfill – machine drains until empty + lmin.

A02 = Heater Relay open circuit/short circuit or Thermistor or Safety T/Stat o/c or s/c or Element machine fills to Level Switch & Wash Pump runs.

A03 = Thermistor open circuit /short circuit – machine drains until Level Switch resets +1minute

A04 = Unable to sense/reach temperature in 70mins. – machine drains until Level Switch resets + lminute

A05 = Level Switch not resetting in within 3′ 20″ of drain commencing – machine drains until Level Switch resets +1 minute

A06 = Not used see also H20 at end

A07 = Wash pump Triac closed/open circuit – check that Drain Pump is not disconnected or Aquastop operated

A08 = Auxiliary Wash Pump Triac closedlopen circuit – check Wash Motor operation- machine drains until Level switch resets+30″

A09 = Main Wash Pump Triac closed/open circuit – cheek Wash Motor operation- machine drains until Level Switch resets+30″

A10 = Fill Solenoid valve Triac closedlopen circuit – check valve/operation – machine drains until Level Switch resets+30″

A11 = 1/2 load Solenoid Valve Triac or alternating Wash Motor action – check Solenoid Valve operation & alternating Motor action, replace Module if required – machine drains until Level Switch resets +30″

A12 = Relay with open circuit – check Heater, replace Module if required – machine drains until Level Switch resets+30″

A 13 = Dispenser Triac incorrect operation closed/open circuit – Wash Cycle completes but with Dispenser Lid notfunctioning correctly

H20 = Static ‘Fill Time exceeding 6 minutes – cheek for blockages/low pressure

5)b) Faults with no Fault Code display

* Solenoid Valve Triac malfunction closed/open circuit -. Wash Cycle completes but with Salt collection not functioning correctly ie, hard water problems

* Fan Triac &/or Heater malfunction closedlopen circuit -. Wash Cycle completes but with poor Drying

* Eeprom malfunction – appliance finishes cycle before it is completed & stops.

Should a fault occur in use, the Fault Codes above will be displayed & should initially be used as a guide in your diagnosis.. Note that after switching on the machine upon your arrival, a short delay may occur before that fault is displayed.

[Author]

Posts