[cmccarthy81]

Sigh, and then a few congratulatory beers.

[cmccarthy81]

Dave

Machine up and running as of yesterday!

Really happy with that! Thanks for help.

Craig

[cmccarthy81]

Dave

Thanks for clarification – all ordered and ready to attack on good friday!

Thanks
Craig

[cmccarthy81]

Dave

That’s a great help. Thank you – I will look to get the mid range brushes and go for it as you have suggested.

Could you just confirm what you meant by ‘run the lowest part of the angle’? I assumed you mean file brush enough that the lowest corner of the chamfer to be contacting the motor?

Noted reference running the machine empty to check spark, and also building up in terms of loads. Very helpful and much appreciated, thanks for taking your time to reply.

Regards
Craig

[cmccarthy81]

Dave

Please see the motor casing photos below; there wasn’t so much a label, just a stamp.

https://imgur.com/4WrUxzy
https://imgur.com/1L3HJVO

The Bosch brushes are spot in terms of size, although I don’t know the original length of course. I was wondering if there was any problem in terms of compatibility with material/angle of chamfer?

Also, is the non genuine part sufficient? The machine was in our house when bought, but assume it’s pushing 15 years old now.

Thanks
Craig

[cmccarthy81]

Dave

Thanks for reply; please see below….

https://imgur.com/fftso7c
https://imgur.com/rSgg0t6
https://imgur.com/MiQEUSR

The squared paper is not representative, just my notepad!

Thanks for any advice.
Craig

[Author]

Posts