[cocayoho]

Re: f &p 051 code

Hi penguin45
Tilted the machine back, removed the base plate, and located the three wires to the sensor I think! These are red, Blue and Yellow? Yes? If so, I have removed them, none are corroded or were loose. There was a lot of water in the connectors though! There are none of the rusty streaks or powder stains on the actual rotor outer as mentioned elsewhere in this forum. Also noticed that when turning the actual rotor by hand that it feels “notchy” . Is this normal?. It is not hard to turn and seems like it is normal in the action. Connected everything back up, and still have the same problem, the water solenoid attempts to open, yet the tub wont rotate, as I have read these do when filling. Then it shuts down and beeps with the third light from the left showing. Now when going back to dignostic shows 0001 0000.
Assume the rotor sensor is u/s? Can these be replaced? I also pushed the test button and got the cold water to run through the solenoid in this mode, so I assume that is ok. I live in Victoria, Aus.
Thanks again for any help, Jim

[cocayoho]

Re: f &p 051 code

Thanks Penguin 45 ! Missed that msg. Will have a look and report back.
Regards Jim

[Author]

Posts