[craighowieson]

Re: Hygena AHY 8101/1 integrated – Drainage Problem

As discussed had a go, followed outlet hose back to small plasic pump at bottom. stipped out and cleaned. all going well fitted back again and ran on cold. Water leaked all over base of dishwasher. Can you confirm exactly where the washer sits on this pump, is it pushed on as far as it can go (stretching washer a little or does it sit insude the female connection ie the pipe from inside the dishwasher to the pump.

Also the pump is connected using 2 clips and a screw, the clips are ok but the screw fixing is burst so it’s not getting a great hold. Should thier also be other clips attached to the plstic mold of the dishwasher at the back of where the pump sits not just the side,

If so thier gone, so can you buy the casing that the pump fixes onto or is it an intregal part of dishwasher.

A lot to take in, sorry

Thanks for the guidance

[craighowieson]

Re: Hygena AHY 8101/1 integrated – Drainage Problem

thanks for your reply

try anything once is this a hard job

[Author]

Posts