[davedel]

Yeah it does, for the 3 minutes it’s allowed to work…

[davedel]

The ‘water container’ light only comes on when the program is finished, ‘end’.
Its my parents dryer, I only recently found out about the ‘water container’ light coming on at the end.
The program will run perfectly as long as the float switch is down. As soon as I move it up, the timer will change to 3 minutes.
I put an ohmeter across the drain pump and it was about 700 ohms. I suppose this is ok?

[davedel]

I have now removed the pump at the back. The machine will work fine until i move the the float switch up – the float switch in the pump well. I have tested this with the pump disconnected from the wiring loom and it is the same result.
As soon as i move the float switch up, the remaining time changes (e.g. from 2 hours) to 3 minutes.
I have still no idea what or why is going on! Surely an on/off switch should not be causing me much grief!

[Author]

Posts