[DEMPSEY1965]

Re: Creda sensadry reversair model 37751

Also can you tell me which thermostat goes where as they are not similar. The one on the right has a little hole in with the terminal above and below this is coloured black and the one on the right is grey with the terminals side by side. The new kit has the terminals on both stats side by side.

[DEMPSEY1965]

Creda Sensadry model 37751

Hi All,

My Creda Reversair Sensadry fails to produce any heat so I replaced both stats as a starter. When I turned on the machine the problem still exists where the element produces heat for about 30 seconds then just dies. Any ideas what else could be the problem. I do appreciate your help.

Regards

DEMPSEY

[DEMPSEY1965]

Re: Creda sensadry reversair model 37751

Hi All,
Help! I have fitted both the stats and the heating element seems to cut out after about a minute, any ideas what this can be?

[DEMPSEY1965]

Re: Creda sensadry reversair model 37751

Thanks Steven, just wanted to make sure. I have also ordered a pair of new pulleys to replace my old squeaky ones. Out of interest what is the best way to go about replacing? What I mean is what panels etc to remove as I don’t want to remove stuff that is not necessary.

Many thanks

[DEMPSEY1965]

Re: Creda sensadry reversair model 37751

Thanks Steven, I have looked at the old ones and they are similar to the 2nd type as the terminals are not flat but point outwards. Do you know what the additional wires are for? Can I just replace the stats using the old wires?
Thx

[DEMPSEY1965]

Re: Creda sensadry reversair model 37751

Hi, apologies for not getting back sooner and thanks for the reply. I will check the hose etc for blockages. The model number is 37751 if that is any help.

[Author]

Posts