DENO

Forum Replies Created

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • in reply to: BOSCH WFF2001 WASHING MACHINE #205512
    DENO
    Participant

    Re: BOSCH WFF2001 WASHING MACHINE

    Penguin45 wrote:I think there’s a locking tab at the top.

    Penguin45. :

    Looking at the new switch just received I can see that there are 4 lugs and the release tab mentioned above.
    DISCONNECT FROM THE MAINS FOR SAFETY FIRST
    From inside the machine the there is a Plastic locking TAB in the centre at the top of the Switch which needs to released towards the back of the machine ❗ and lift the whole switch upwards about about 10mm and pull out. The New Switch fitting is a reversal of this and you should hear a click when the Release tab has locked into place.

    Now One happy Owner; 😀 Also discovered the machine is older than I thought. First fault since purchase in March 1998. So pretty good service so far.

    Many Thanks to The Penquin and Jim for your help.

    in reply to: BOSCH WFF2001 WASHING MACHINE #205509
    DENO
    Participant

    Re: BOSCH WFF2001 WASHING MACHINE

    DENO wrote:If the On/Off is failing and I HOLD IN the switch manually longer than 10 secs is it likely to cause any further problems.

    I would like to try if the Machine fills with water or the spin cycle if this is possible, or do I have to replace the switch first before going ahead?

    Thanks Penguin 45

    Thanks Penquin45 and Jim : Can’t quite figure out how the ON/OFF switch comes out; I can see 4 corner lugs but it won’t release, unless I am overlooking something else !!

    in reply to: BOSCH WFF2001 WASHING MACHINE #205503
    DENO
    Participant

    Re: BOSCH WFF2001 WASHING MACHINE

    If the On/Off is failing and I HOLD IN the switch manually longer than 10 secs is it likely to cause any further problems.

    I would like to try if the Machine fills with water or the spin cycle if this is possible, or do I have to replace the switch first before going ahead?

    Thanks Penguin 45

Viewing 3 posts - 1 through 3 (of 3 total)