Dlish1971

Forum Replies Created

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • September 20, 2013 at 8:12 pm in reply to: Beko WMA1512w draining as it fills #401134
    Dlish1971
    Participant

    Re: Beko WMA1512w draining as it fills

    Just in case anyone is interested, I managed to get a used control board off ebay for £25.95 and the problem is sorted 😀

    September 18, 2013 at 4:06 pm in reply to: Beko WMA1512w draining as it fills #401133
    Dlish1971
    Participant

    Re: Beko WMA1512w draining as it fills

    Well I’ve replaced the thermostat, which just pulls out and pushes in again and the fault is still there. It turns out that not disconnecting the leads gave the 5k resistance reading (it’s only1.6ohm and the new one was 1.8ohm when disconnected).

    Not sure wether to try replacing the control board or just give up and buy a new machine.

    September 13, 2013 at 9:11 pm in reply to: Beko WMA1512w draining as it fills #401132
    Dlish1971
    Participant

    Re: Beko WMA1512w draining as it fills

    Ok, so I’ve tested the thermostat and its reading 5kohms which seems a bit high from what I’ve read on here.

    Does anyone know if these are just a push fit part?

    Cheers

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)