donmact

Forum Replies Created

Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • December 18, 2009 at 9:02 am in reply to: NEFF COMBI OVEN H5972N0GB/01 LANGUAGE #306648
    donmact
    Participant

    Re: NEFF COMBI OVEN H5972N0GB/01 LANGUAGE

    MANY THANKS, GOT ME OUT OF A SPOT

    December 17, 2009 at 6:50 pm in reply to: NEFF COMBI OVEN H5972N0GB/01 LANGUAGE #306646
    donmact
    Participant

    Re: NEFF COMBI OVEN H5972N0GB/01 LANGUAGE

    unfortunately it’s a rented house and no books, maybe try and download a user manual. Thanks anyway, Don

    November 13, 2009 at 3:21 pm in reply to: NEFF COOKER HOOD D8150N1GB-01 #303462
    donmact
    Participant

    donmact wrote:Thanks, shall try that tomorrow

    Worked a treat, many thanks, Don

    November 12, 2009 at 7:09 pm in reply to: NEFF COOKER HOOD D8150N1GB-01 #303461
    donmact
    Participant

    Thanks, shall try that tomorrow

    October 16, 2008 at 5:39 pm in reply to: Indesit WIL 103 UK and I’m stuck! #265279
    donmact
    Participant

    Thanks again Martin, I’ve ordered up a sensor so hopefully??

    October 16, 2008 at 1:51 pm in reply to: Indesit WIL 103 UK and I’m stuck! #265277
    donmact
    Participant

    Thanks Martin, tried that when at the call. The NTC reads 34.6K and the WILD says 23K if I remember correctly. The thing is, should it fill and empty on fault F03?
    Cheers, Don

    November 29, 2007 at 4:31 pm in reply to: HOTPOINT DRYER CTD00P CONDENSATE PUMP RUNNING #235737
    donmact
    Participant

    Re: HOTPOINT DRYER CTD00P CONDENSATE PUMP RUNNING

    Many thanks Jim

    September 12, 2007 at 12:41 pm in reply to: rangemaster 110 #227307
    donmact
    Participant

    aAs mike1 said, the motor assembly is behind a cover on the rear of the oven secured by 3 self tappers along the top and one either side. remove the screws and the cover will hinge down on locating tabs and can be removed. The motor assembly is held in by 3 nuts on the inside of the cavity and the whole assembly can be removed. The part number for the motor and mounting plate is A0977769

  • Author
    Posts
Viewing 8 posts - 1 through 8 (of 8 total)