easyeieio

Forum Replies Created

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • in reply to: NEFF Fan Oven not working U1661N0GB/02 #445060
    easyeieio
    Participant

    Re: NEFF Fan Oven not working U1661N0GB/02

    Just thought I’d report back, and say thank you for the assistance. I took the oven out and replaced the fan, and the element too for good measure, whilst I had it in bits . The old fan span when pushed, but I guess the motor had gone – the whole thing was incredibly gummed up with nastiness from years of use. All cleaned up, installed, and working now, fantastic hot oven at last!

    in reply to: NEFF Fan Oven not working U1661N0GB/02 #445058
    easyeieio
    Participant

    Re: NEFF Fan Oven not working U1661N0GB/02

    Thank you for the advice guys, I’ll report back once I removed it and (hopefully!) sorted it
    Cheers
    Ian

    in reply to: NEFF Fan Oven not working U1661N0GB/02 #445056
    easyeieio
    Participant

    Re: NEFF Fan Oven not working U1661N0GB/02

    Cheers, is it normal for the element to stop glowing red then after initial start up? Or is that because fan is not working?

    in reply to: Indesit IDL 40 flashing lights two (wash) and four (dry) #309108
    easyeieio
    Participant

    Re: Indesit IDL 40 flashing lights two (wash) and four (dry)

    Hi, many thanks for the reply.

    I actually read through some previous threads, and decided to take the front cover off. Sure enough the temperature sensor was hanging loose, so I reattached it to the back of the dispensor unit. Have just run a cycle, with no problems!

    Saved getting wet too … almost …. I didn’t attach the drain properly, so got a bit of a soaking floor until I spotted it!

    Thanks again
    Ian

Viewing 4 posts - 1 through 4 (of 4 total)