[Evkessel]

Nah, it is just still Err 06. Same issue. Must be the board then.

[Evkessel]

The dryer stops after 10 seconds they say, without any error or beeps. I will check tomorrow morning myself again.
Maybe any thoughts to check for or think of?

I think of check with all drying programs, check whether heating element is doing what it should, check of program actually stops or pauses (door switch maybe?).

[Evkessel]

After a week, the error is still gone.
However, I believe that it’s not drying as it was before. The washes are not dry as expected.

I will do some temperature tests, although I measured the heater elements and safety switches and they seemed ok.
I would expect another error displayed when the heater element malfunctions. There is none.

Any additional hints?

[Evkessel]

Makes sence.
To be honest, after disassembly, measuring on the PCB, connecting all back, the dryer seems to work….
If it holds, I suspect the connection on the PCB after all….

[Evkessel]

Hi, did you manage to fix this case [USER=”47916″][/USER]e ? I have the exact same issue. Started with easy fix, the NTC was loose from the connector (cause by cleaning the lint compartment). After connecting, dryer was ok.
Now the same error.
NTC is ok. Did some measurements on the PCB, nothing noticeable. Still E06…

I’m curious…
​

[Author]

Posts