Simon46 wrote:Water or crud in airtubes going to inlet valve or pressure switch. Mechanical diaphragm on valve may have been forced to shut off electric inlet valve. Pressure needs releasing by pulling tube off and tapping valve. Unplug power if your going in.
S.
are there any diagrams so we know what we are looking for?
well, we took the pipes out as advised and cleaned them, the u shaped tube underneath was full of muck! after putting it all back together and putting it on a wash it filled with water, and began to wash, however it seems as though the heater is kicking in but the intake of water has stopped 🙁
thanks for the reply, its just done a wash, got stuck just before 3, turned the dial till it started again, and it completed the wash. Hot water, heat to dry etc, arm sprayers moving.