Forum Replies Created
-
Posts
-
Re: bosch wff2000gb/01 how to replace dispenser to drum hose
Thank you. I have visualised the drum end clamp now with a torch and a mirror.
Re: Bosch WFF2000GB/01 Constraints on replacing carbon brush
Removed motor today. Only 2 wire ties. I mis-counted. I have 2 further, hopefully, final, questions.
Would you clean the stator with a paint brush, or a can of compressed air?
Secondly, this world seems to be one without thread compounds or quoted torque settings. I had to use a socket arm to release the motor bolts. I note the angle of the bolt thread pitch, and the large bolt head flange. They were torqued to circa 120 Newton.metres. Washing machines rotate, and vibrate from uneven loads. Are they held together by all fasteners being tightened according to the strength of the operator, in other words, as tight as possible?
Re: Bosch WFF2000GB/01 How to replace Drum Paddle Lifter
I take it the procedure is to
remove front
remove weight
remove drum and undo marginal wire clips at front of drum assembly to remove inner drum and reveal whatever fasteners are used.No doubt there is a seal on the outer drum opening which will need to be replaced, if still manufactured.
Do you recall the nature of the fittings holding the lifters in place?
