FlappySocks

Forum Replies Created

Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • March 12, 2008 at 3:58 pm in reply to: Whirlpool ADG 7550 #245087
    FlappySocks
    Participant

    Re: Whirlpool ADG 7550

    FlappySocks wrote:I have got my pump, and it fits. The only problem is that the power connector is different. Using spade connectors will solve that, except that there are no markings on either wire, or pump connector as to which is positive and which is negative. 😕

    Forget that… the connector broke apart when I disconnect it, and got stuck in the original pump. 😳 Fixed it now 😀

    March 12, 2008 at 3:03 pm in reply to: Whirlpool ADG 7550 #245086
    FlappySocks
    Participant

    Re: Whirlpool ADG 7550

    I have got my pump, and it fits. The only problem is that the power connector is different. Using spade connectors will solve that, except that there are no markings on either wire, or pump connector as to which is positive and which is negative. 😕

    March 8, 2008 at 8:31 pm in reply to: Whirlpool ADG 7550 #245085
    FlappySocks
    Participant

    Re: Whirlpool ADG 7550

    Thanks Penguin. Looks straightforward enough. I guess I could use jubilee clips if I haven’t the right crimp tool.

    March 8, 2008 at 5:43 pm in reply to: Whirlpool ADG 7550 #245083
    FlappySocks
    Participant

    Re: Whirlpool ADG 7550

    Look the same. I assume its not possible to change it from the front.

    March 8, 2008 at 4:46 pm in reply to: Whirlpool ADG 7550 #245081
    FlappySocks
    Participant

    Re: Whirlpool ADG 7550

    Ordered, thanks.

    March 8, 2008 at 4:28 pm in reply to: Whirlpool ADG 7550 #245079
    FlappySocks
    Participant

    Re: Whirlpool ADG 7550

    Thanks. Can anyone recommend a place to get a pump? How do I get to it…under the machine?

    March 7, 2008 at 8:29 pm in reply to: Whirlpool ADG 7550 #245076
    FlappySocks
    Participant

    Re: Whirlpool ADG 7550

    It is draining, however, I tried it again today, and discovered that water is leaking onto the floor. Not sure from where.

    March 7, 2008 at 8:50 am in reply to: Whirlpool ADG 7550 #245074
    FlappySocks
    Participant

    Re: Whirlpool ADG 7550

    I got the control board out. Looks ok. Can anyone tell me what the connector codes mean.

    HEW
    MS
    DS
    WI
    SPM
    DPM
    WV1
    DDDR
    WV2
    VM
    DB
    NTC
    FM
    KL
    SA

  • Author
    Posts
Viewing 8 posts - 1 through 8 (of 8 total)