Forum Replies Created
-
Posts
-
Hi Dave,
There is a switch yes. I had this out and tested the reed switch with a magnet and checked for continuity, this read ok 0.3 ohms. Yes the LEDs on the display stop too.Hi Dave, I replaced that capacitor you mentioned, the appliance switched on and worked for a bit but when I closed the freezer door the compressor stopped and the lights on the front panel switched off then on. This kept doing this all the time the freezer door was closed. If I kept the freezer door open the compressor would run and the lights stayed on.
I closed the freezer door and the appliance was working for about 2 hours then went back to how it was before with the compressor, lights on the PCB front panel and fans switching on and off very couple of seconds unless I leave the freezer door open.
Does this now need a new pcb or could anything else be causing the issue?Morning Dave,
I have been unable to upload a picture of the module because the file size is too big. Is there another way I can share the picture of the module?
Hi Dave sorry for hijacking this thread but I also have the same issue with lights flashing and compressor starting, stopping.
i have run auto test and checked heaters, fans, diverted valve and sensors are ok.
Model is KGU31123GB/07
FD8405
Any ideas what capacitor I need to replace as the one shown in this is slightly different from your previously posted picture.
Many thanks.
