Forum Replies Created
-
Posts
-
Re: SMEG dishwasher DWI 409C error code E1
PCB was at fault – new one now in and working fine.
Many thanks for the help Penguin45
Gaz
Re: SMEG dishwasher DWI 409C error code E1
Hi,
Stripped the machine down (to the best of my abilities) on Sunday, no blocked up pipes – all wires and connectors look fine (cleaned all connectors on refitting).
Mains suppressor shows no sign of damage or fault – any way to test in isolation though ?
But, feeling more this is a pcb fault (no burnt or cracked tracks though – but will get the magnifying glass out).
Gaz
Re: SMEG dishwasher DWI 409C error code E1
Just put the new soap dispenser in, and getting the same, i.e.
Performed the system reset a few times, after which the machine runs the rinse cycle, moves onto the 2nd delicate cycle, opens the soap dispenser, then seems to get stuck on the 2nd cycle, constantly activating the soap dispenser solenoid.
Noticed that water is flowing into the dishwasher, as can now see with the righthand panel removed. Left the machine running for 15 mins with the dispenser activating, opened the door and it had a fair amount of water (which was cold).
Any advice on the next step(s) please ?
Garry
Re: SMEG dishwasher DWI 409C error code E1
Disconnected the 2 wires (white and blue) connecting to the dispenser solenoid – the dishwasher is not starting at all now – program lights up but does not progress at all. Did I disconnect the wrong component ?
Removed the right panel, no blown components there.
Garry
