gegsy

Forum Replies Created

Viewing 15 posts - 2,071 through 2,085 (of 6,724 total)
  • Author
    Posts
  • in reply to: Very Bad Day! #220435
    gegsy
    Participant

    Re: Very Bad Day!

    Did the contracter get the erm …. hump 😆

    in reply to: Very Bad Day! #220433
    gegsy
    Participant

    Re: Very Bad Day!

    goosegreen wrote:……..when I noticed I Had driven over a small bump. No I had driven over the contractors CAT 🙁 🙁

    :rotl: :worthy: :wave: best laugh I ve had for ages. I am a cat lover but that is so funny ,I am sorry 😆

    Greg

    in reply to: Indesit Moon Error Codes #220337
    gegsy
    Participant

    Re: Indesit Moon Error Codes

    Moon Crater……………….. WEEE instigation imminent

    Greg

    in reply to: Bosch SMS9022/14 getting stuck at start of cycle #219249
    gegsy
    Participant

    Re: Bosch SMS9022/14 getting stuck at start of cycle

    Hi
    Lets start with the usual suspect –
    Remove L/H panel and locate the fat “S” shaped hose that runs from the water matrix to the sump.
    Remove it and clean/rod thoroughly. Re-assemble and test, let us know how you get on 😀

    G

    in reply to: Oven wont get hotter than about 100c #220207
    gegsy
    Participant

    Re: Oven wont get hotter than about 100c

    Hi
    Anywhere between 15 – 30 ohms would be normal.

    Greg

    in reply to: Bosch WFP 3300 Smelling #220401
    gegsy
    Participant

    Re: Bosch WFP 3300 Smelling

    Hi andy
    This link may help you 😀 http://www.ukwhitegoods.co.uk/modules.p … age&pid=43

    Greg

    in reply to: Indesit Moon Error Codes #220332
    gegsy
    Participant

    Re: Indesit Moon Error Codes

    Moon Rocks………………….. Suspension problem or Imbalance detected

    Slogan – The Moon by Indesit…………. Orbiting the earth? WEE will see 😆

    in reply to: Bosch WFO 2866/gb #220239
    gegsy
    Participant

    Re: Bosch WFO 2866/gb

    Hi Steven
    If you should require the spare, it is available from spares@ukwhitegoods.co.uk, quoting p/no 445337.
    List price is approx £90 odd + the usual.

    Greg

    in reply to: Bosch WFO 2866/gb #220237
    gegsy
    Participant

    Re: Bosch WFO 2866/gb

    Hi
    Just look at the pcb carefully and see if you can spot any bad joints, they are usually pretty blatant 😉

    We are getting close to pointing you towards repair@ as the fault doesnt appear to be a straightforward fix on here, sorry.

    Greg

    in reply to: Bosch WFO 2866/gb #220234
    gegsy
    Participant

    Re: Bosch WFO 2866/gb

    Hi
    It may be worth you removing the module and looking for any poor solder joint/s around the relay pin/s, esp one feeding the heater.

    Power off of course :plug:

    Greg

    in reply to: Bosch WFO 2866/gb #220227
    gegsy
    Participant

    Re: Bosch WFO 2866/gb

    Considering you have changed almost everything connected with the heating circuit, there can really only be a break in the wiring loom somewhere or the module is in fact defective IMHO 😕
    Also can you tell us is it a GB/01/05 or 07 😉

    Greg

    in reply to: Oven wont get hotter than about 100c #220205
    gegsy
    Participant

    Re: Oven wont get hotter than about 100c

    Yes, I must stop assuming 🙂
    To clarify, grill element at top is a dual element and when appliance is switched to oven mode , half the element is activated along with the element under the floor of the oven cavity. Hope that clears that up. We await the OP’s reply 😀

    Greg

    in reply to: Oven wont get hotter than about 100c #220203
    gegsy
    Participant

    Re: Oven wont get hotter than about 100c

    Thats what I thought initially Mr P,but……………

    bodgit0_0 wrote:have had the cold element checked whilst in germany and it checks out OK

    Greg

    in reply to: neff oven RRR on temp display #220211
    gegsy
    Participant

    Re: neff oven RRR on temp display

    Hi
    rrr will be displayed after a short circuit, so get that meter out on the elements would be my first plan of attack 😉

    Greg

    in reply to: Oven wont get hotter than about 100c #220201
    gegsy
    Participant

    Re: Oven wont get hotter than about 100c

    Hi
    Sounds like a selector fault ie damaged contacts.
    Best thing to do is inspect selector contacts (power off of course) and see if there is anything obvious.
    Also you could check wiring from duff element back to selector using a multimeter for continuity.

    Greg

Viewing 15 posts - 2,071 through 2,085 (of 6,724 total)